BMW R1200RS - P3 Installation

    2014-16 Models
    The water cooled R1200RS requires slightly different wiring than previous models.


    Remove the rear seat and connect the controller's red wire to the green/white wire in the connector block at the front of the seat area, as shown in this photo of the underseat area and the close-up below..

    Next, connect the controller's white wire to the top/center (gray/black/yellow) wire going into the tail/brake light housing at the rear of the bike, and connect the controller's black wire to the brown wire as shown in this photo  of the Tail/Brake Light Wires..